This could mean one of two things.
An intermittent chirp is probably an indication of a defective smoke detector.
A consistent chirp is probably an indication of a low battery condition and the smoke detector requires a new battery.
This could mean one of two things.
An intermittent chirp is probably an indication of a defective smoke detector.
A consistent chirp is probably an indication of a low battery condition and the smoke detector requires a new battery.
This is usually caused by several factors.
Use of non-brand named bulbs.
Larger wattage bulbs, which cause excessive heat build-up shorting the life of the bulb.
Power Surges.
With deregulation of the utility companies in most areas of the country, the cable or telephone companies are no longer responsible for the equipment or wiring in your home. This responsibility has fallen to you and your electrical contractor. Therefore, when a problem arises, we recommend you us. Most TV and telephone utilities will still service within your home for a substantial fee. This service, as in the past, is no longer free.
Modern Recess Cans are rated for a maximum wattage bulb and are equipped with a thermal device that does not allow a bulb larger than that rating. If a larger wattage bulb is used, as the excess heat builds up, the thermal device will shut the can off until it cools. This is a safety device to protect your home against fire.
Yes. Within reason, if the quantity of lights creates a load greater than the capacity of the circuit breaker, the breaker will trip off. In this event, additional circuits may be required to accommodate your holiday display.
No – not “totally.” Surge/Lightning Protection only offers additional levels of protection. Nothing can guarantee completely against Mother Nature and where she chooses to strike.
Yes. This is a common occurrence when large motor/compressor loads start. These devices cause a minor momentary voltage drop, demonstrating itself as the blinking in your lights. This has no negative effect on the electrical equipment within your house.
Yes. Though, if the device exceeds the capacity of the circuit, the breaker will trip off.
Yes. Though, if the two loads exceed 20 Amps, your breaker will sense overload, do its job, and trip off. Under this condition, you must plug one of the appliances into a different kitchen outlet on a different circuit, in order to balance the load.
Unless you made provisions with the builder for a dedicated circuit, the outlets in your garage are GFCI Protected per National Electrical Code. This device will not tolerate the additional resistance load created by refrigeration equipment. The GFCI senses there is a fault, and therefore trips off. The only cure to this problem is to provide a dedicated, non-GFCI circuit allowable by code.
Here are several ways to contact us